***We will NOT be Flashing any ECU's 3/29/20 - 4/5/20***
2017-2020 Polaris RZR Turbo 2015-2020 XP, 1000 XP & 1000 Highlifter Edition ECU Flashing !!!
You Like Power ??? Did you add a Exhaust, or do you just want your factory utv to run cooler & better ??? Well don't look any further, We don't pry apart your computer or require you to buy extra hardware/software, or expect you to flash it yourself, All you got to do is pull off your ecu, mail it in, with your ph# in the box, or even better just bring up your utv to our dealership & we will plug right into your factory diagnostic cable & flash it & send you on your way, all in about 15 minutes.
We do Fuel, Timing, Boost, Limiters, Rev Limiters, Speed Limiters, Torque Limiters, Seatbelt limiters, Fans on Early, etc, etc. It's Plug & Play, that easy.
We don't pry apart your factory stamped & sealed computer to reflash it & then try to caulk it back together in the hopes that it don't leak when you go mudding or wash your bike, or Require you to buy extra hardware/software to do it yourself, We don't just supply you with a tune, We put it on there for you, we plug rite into your factory computer just like the manufacture would.
We have spent hundreds of hours writing tunes on our Two In House Dyno Jet Dynos, our tunes are dual cylinder tunes, unlike others we don't just put one wideband in the exhaust & adjust both cylinders equally till they reach a combined number. we individually tune each cylinder so there is no chance of 1 cylinder running lean & the other running rich.
Chances are if you've done it we've already got a tune for it....
What makes us better ??? Besides 2 decades of experience Tuning Power Sports Vehicles & countless hours writing & testing tunes for just about every year, make model atv/utv, there is, We do everything rite in your computer just like factory, it's Plug & Play.
Don't waste $ on one of them blinky box "tuners", or other hardware, not because they cost $250-$399 but because all they do is piggy back between your factory fuel injector cables & fool the already preset signal going to them, & you don't have a bunch of wires or have to worry about them getting wet & then shorting out. What we do is all done right in your factory computer just like the factory would!!!
Add Power & Don't look back... We will make your utv run cooler, make more power & over all just run better & make your throttle so much smoother, snappier throughout the entire rpm range, We also offer factory tunes for those that run lean from the factory, bypass seat belt limiters, & also offer tunes that dealer will never know, Won't void your factory warranty!!!
We can adjust Ignition Timing, Fuel Tables, Boost, Engine Limiters, Fans on earlier & in Race Applications, Remove Rev Limiters, Speed Limiters & allow Gas & Brake Launch Control. (Please contact us For Race Applications First)
We currently have tunes for 2017-2019 RZR Turbo & 2015 1000 XP & Highlifter Edition. We are currently working on & testing tunes for other Polaris utv's & atv's, (If you are local & would like to be a tester, please call or come to the store).
All you got to do is hit the throttle, all our tunes are done in house on our state of the art DynoJet Dynometers, fuel, timing, boost, etc rite on the dime & ready to roll.
You can either bring in your atv/utv to our Memphis, TN location & we can ReFlash it rite on the spot, only takes 10-15 minutes, or you can simply mail your computer to us & we can flash it & mail it back to you the next day.
Ecu "Computer" removal is easy, all you got to do is remove 4 Torx bolts located behind your driverside seat on 2 seaters & behind back seat on driverside on 4 seaters, pull back the levers & pull, removing your ecm from your vehicle, drop it in the mail with your name & phone# in the box & send it to our (Memphis, TN Store Location), We will get it a couple days, & personally call you to ask specs or what else you want done, flash to your liking & then call you back to verify address get credit card payment & mail back out to you the next day.
We simply plug into your factory connector, make a copy your factory tune, save it under your name, then make changes to your fuel, timing, etc & then in a couple days you got your ecu back & are riding with a extra smile when you hit the gas!!! (Custom tunes are available) This does require dyno time at $65 a hour & must make appointment first, but being we don't have to remove or pry open your computer each time to make changes in most cases it can be done in less then 2 hours, we are constantly making new tunes as new products come available.
Ever need any additional modifications done or just want to go to a bigger tune we only charge $50 to make changes.
*Also Can be changed back to Stock at Anytime.
The way it works: You can bring in your utv & we can reflash it on the spot only takes 10-15 minutes, or you can simply remove your computer ECM & drop it in the mail with your name & phone# in the box & send it to our (Memphis, TN Store Only) & when we get it a couple days, we will personally call you to verify what we are doing, we make a copy of your factory tune with your name, make changes to your computer, then one of our girls will call you back to verify your address & take your credit card payment & off you go, in a few days you got your ecu back & saying man is Wholesale ATV Awesome!!!
Guaranteed!! If you don't like it we'll either reflash, make changes or return it back to stock & return your $.
We can Adjust Timing, Adjust Fuel Tables, Raise Speed Limiters, Remove Torque Limiters, Raise Rev Limiters, & Gas & Brake limiters & Turn off Seat Belt limiters, etc, etc.
Now you can Check out Online, Print your Receipt, and Mail in with your ECU to:
4030 Austin Peay Hwy
Memphis, TN 38128
A Tech will contact you for specifics before flashing your ECU and when it is finished, the website will send you an email with the tracking number for the return of your computer.
***If you do not have a printer or do not want to check out online, you can still send your ECU in with a piece of paper that states your name, number, and return address and we will contact you when we receive it prior to flashing.
***Don't forget to include your name & phone# in the box with your ecu.